TRANSFER COLOR: WHITE
TRANFER TYPE : LOW HEAT:
- Preheat press to 325 Degrees fahrenheit.
- Set your pressure to Medium or approximately 5-7 PSI.
- Lint roll your choice of garment and center on your heat press.
- Once your press is heated to 325 degrees, prepress your garment for 5-7 seconds to remove wrinkles and any moisture that may be present in the garment/item.
- Place your transfer face down where the design is laying on your garment/item.
- At this time you will want to make sure your garment/item is centered on your press or in your desired location. You may also apply some heat proof tape to make sure the transfer does not move when pressed.
- Lower the handle on your clamp heat press for 7-10 seconds (I always press for 10 seconds)
- Once your 7-10 seconds has passed or until your heat press beeps, raise the press handle and peel the transfer while it is still hot. NOTE: If you wait too long the to peel, the transfer may re-adhere to transfer paper again.
- If after you press your transfer and attempt to perform a hot peel, your screen print does not release from the transfer paper, repress for 2-4 Seconds.
- Teflon sheets are not needed when pressing screen prints. However, there may be instances where a Pressing Pillows would need to be used, For example: if the item has seems that may interfere with pressing the transfer evenly, such as a onesie or toddler shirt.